ALL200INSTALLATION INSTRUCTIONS Aladdin Light Lift, Inc. (256) 429-970061 Shields Road (877) 287-4601Huntsville, AL 35811 www.aladdi
STEP 23Adjust canopy and telescopic conduit assembly so contact plates meet before the canopy touches the ceiling. See Diagram I.Never allow the chand
STEP 27Tighten xture coupler set screws using supplied 3/32” Allen wrench. Fixture coupler set screws have thread lock already applied at factory. S
ALL200 TROUBLESHOOTING GUIDETECH SUPPORT: (877) 287-4601 Monday through Friday 8:00am to 4:00pm CSTI. Troubleshooting and installation must be perfor
ALL200 TROUBLESHOOTING GUIDE cont. 1. Conrm ALL200 is at the CEILING POSITION. If not, use the controller to operate the ALL200 to the CEILING POSI
Warranty AgreementAladdin Light Lift, Inc. warrants its chandelier light lift unit for one year from the date of purchase. e warranty includes all p
Read the following guidelines prior to installing the ALL200:I. e ALL200 must be installed by a licensed, bonded and insured electrician. II. e ALL
STEP 1Determine where ALL200 will mount on ceiling joists. ALL200 must be installed level, in an accessible location directly above chandelier.Never
STEP 5Attach the 1/2” conduit connector on ceiling box to bottom of conduit assembly. Once completely inserted, tighten set screw on conduit connecto
STEP 7Position ALL200 where ceiling box will be centered in ceiling hole. Weight and bottom contact plate assembly should hang down through ceiling h
STEP 9Shim and adjust ALL200 so that winch cable hangs plumb through center of hole in top contact plate on ceiling box. See Diagram E. Look up at c
STEP 11Turn o supply power before wiring ALL200. Turn o motor switch in square box. Wire motor switch with 110V wiring. e 110V motor feed must be
STEP 13Remove dust cover and remove paper tape from winch drum while keeping tension on winch cable.Never operate the ALL200 without tension on the ca
STEP 20Fully thread screw collar loop or threaded stem that was supplied with chandelier to 1/4 IPS xture coupler. If chandelier was supplied with a
Comments to this Manuals